E-Port Wallplate Conversion Plate 15.551.002 roller shutter Be aware of this before

Be aware of this before proceeding any further with these instructions

Do you have a damaged or dirty wall plate

Additional troubleshooting information can be found in Section 4 of the instructions that are in the Wallplate box

4 modes per Connexoon

Built in receiver

E-Port Wallplate Conversion Plate 15.551.002 roller shutter Be aware of this beforeThese instructions detail the procedure for the removal of a Control 10 Wallplate so that a 18650 E Port Controller can be installed using an E Port Wallplate Conversion Plate. Ideally, this procedure should be carried out by an experienced installer as it is important to ensure that there are no short circuits in the charging system which may damage the E Port Controller. You will need to note the positions of the wires on the terminals of the